License Plate Screw Installation Method

Vehicle number must be installed in accordance with the standard, license plate screws must be installed, when installing the license plate frame, the distance between the inner edge of the frame and the license plate number must be greater than 5 mm. Police also explained the definition of "solid screw": this is a "cannot enter" screw, using stainless steel material, can prevent the wind and rain washed away, once installed, the license plate is not easy to be removed by the owner.

Don't look at the license plate screw is simple 8, but if it's your first time to install it and no one has taught it, then don't want to put it on. Even if you put it on, it is possible to see, for example, the hat on the screw may be unstable, resulting in a strange sound, serious screws under the license plate will also scratch the car paint. So when ever you hear a screwdriver, you can easily install license plate screws, think it's a small thing. It's basically layman. Because the license plate screw is a specially designed screw, in the anti-theft do a lot of effort. Below for everyone, how to correct, quickly put the license plate screws installed well.

Preparation tools

License plate and screw bag (self-tapping screw), screwdriver.

Self-tapping screw license plate installation

Put the pre-prepared license plate buckle on the fixed shelf of the license plate, here is a tip, you can consider putting a layer of foot mat on the back of the license plate, this foot mat is very important, many cars when driving to hear the sound of the license plate has a strange noise, eight floors is because there is no such thing. Because the addition of this pad, can effectively prevent the car license plate and bumper impact between the noise. Finally, the self-tapping screw through the anti-theft, and then hang through the license plate holder hole, directly screwed to death on the bumper license plate holder, followed only need to close the anti-theft lid on the finish.

Self-tapping screws and anti-theft bolt license plate installation

This method is much better than the first, anti-theft effect is significantly better. Use a self-tapping screw on the license plate and add the anti-theft bolts used below. Double protection, installation method is similar to the first, the only increase in installation difficulties is that the need for the car license plate holder under the bumper 2 screws need to punch on. This is best to go to the 4S shop to let the professional master help, because this to remove the front of the car under the bottom of the protective partition, the action is relatively large, and then put the hand into the upper gas - spring pad - nut.

In general, the installation of license plate screws is more difficult than it is to see, but easier than you think. At present, the installation method of license plate screwist is mainly mentioned above these two, their point is that the installation is relatively simple and convenient, the effect is relatively strong, but also rust-proof, with anti-theft capability. However, the car management station for the first time on the license plate inexperienced car owners, to the car management license plate, the car management will install on behalf of the car management, but to charge 40 yuan, and the method used is not mentioned above the two, but the license plate directly riveted up. Such an approach, though said, is also solid and beautiful. But I don't mind doing this, first of all, this has to use a special riveting gun tool, the average family does not have this, second, in case the car bumper retired, it will be trouble, have to re-rivet or use other installation methods.