How to avoid the scrapping of aluminum profile shell?

Aluminum profile manufacturers know that it is not worthwhile to scrap the profile when it is bent, and it should not happen, but it can be avoided! So, how to reduce or avoid the scrap of aluminum profiles due to bending? Zhongyilong below Editor to introduce to you.

　　 Aluminum profile shells are various shells made of aluminum alloy as raw materials. It is also a commonly used electronic packaging material on the market. The aluminum profile shell can be cut and die-casted at will. Usually there is a circuit board slot inside, as long as the circuit board is directly inserted, there is no need to fix it.

The processing speed of the shell is unmatched by shells of other materials. The aluminum profile shell uses a die-casting molding technique, which has waterproof and explosion-proof characteristics, so that when it is used as an electrical component shell, there will be no water leakage, which can be well protected. Internal components.

　　How to avoid scrapping of aluminum profile shell:

Aluminum shell

　　 1. Squeeze and straighten

Straightening is a very important part in the manufacturing process of aluminum profiles. Straighteners must pay attention to the strength used for straightening. If the force is too large, it may cause problems such as deformation, closing, orange peel, etc. of the aluminum profile; Will not straighten, causing bending. Therefore, we must grasp the strength.

　　 Second, squeeze frame

　　 This link is also very important. After sawing the fixed length, the aluminum profile will be framed. This fashion framer should pay attention to this: is this material large or small, is it a tube material or a material that is pulled out by a flat die, in general, large materials and tube materials are not easy to cause bending when lifting the frame at both ends However, the material pulled out by the small material and the flat die can easily cause bending when lifting the two ends. At this time, the material should be moved from the two ends to the middle to lift the frame. But some aluminum profiles do not work even this way, for example: louvers, windows, glands, etc., it is necessary to put such materials on the aged aluminum profiles and then lift them into the frame.

　　 3. Surface treatment

The billet has been aged and the hardness has reached the standard, so the aluminum profile is not so easy to bend, but you should pay attention to it when loading the rack. When lifting the material at both ends, try to avoid violent fluctuations as much as possible, which will also cause the aging aluminum profile shell Certain bending.

　　The above is an introduction on how to avoid the aluminum profile shell being scrapped. The aluminum profile shell has good electrical and thermal conductivity, and its electrical and thermal conductivity is second only to silver, copper and gold. Taking the case of an aluminum alloy charging pile as an example, a lot of heat will be generated during work. The aluminum alloy can conduct the internal heat well without damaging the circuit and the casing will not be deformed due to high temperature. Compared with plastic shells, aluminum alloy shells are simpler to process and have better hardness, exceeding the strength of many plastics and metals.