The Typhoon Came, How Is The Machine Tool Equipment In Your Factory Resistant To The Typhoon?

Several typhoons a year, raging the earth, your factory machine tools how to resist typhoons? It's not going to be a defense, is it?

Therefore, for those low-lying, easy to enter the water workshop, we must do a good job in advance waterproof ingestion, try to avoid such a situation! If once the machine machine into the water, then the following from Sheni machine tool factory god operation, may help you to recover some losses!

Before the typhoon: a thorough inspection of all areas of the plant, including workshop doors and windows, open-air sheds, all kinds of open-air shelves or wall installations, rainwater drainage systems, various types of ditches, power circuits and switching boxes and other safety and firmility.

Focus on the inspection of factory materialwarehouse material safety, especially during the typhoon accompanied by heavy rain and strong convective bad weather, warehouse to be waterproof and moisture-proof.

Comprehensively check the strength of flowers and trees in green areas, including all kinds of potted plants, landscape trees, road trees, etc.

To check the safety situation outside the factory, mainly outside the factory encountered large rivers or mountains and slopes, etc. , to prevent typhoon shing rain caused secondary disasters.

Post publicity announcements about the relevant safety precautions to be taken into account during typhoons.

For typhoon intensity, timely adjustment of the factory production plan, in accordance with the general requirements of national defense, typhoon warning to reach the corresponding level, that is, stop production.

In view of the above inspection out of the problem, immediately start to rectify, so that prevention in practice.

After the machine is flooded, we should first carefully observe the flooded part, and then target according to the following method treatment.

First, the mechanical part.

1, the machine tools and components to carry out a thorough cleaning, it is necessary to wash the residual sediment clean, it is necessary to disassemble and clean and fully dry;

2, after drying to be full, oil lubrication, so as not to rust, affect the accuracy;

3, replace the screw and bearings.

Second, the electrical control part.

1, disconnect all power;

2, the entire electrical box electrical components removed with alcohol cleaning, and fully drying treatment;

3, carefully detect the circuit, system interface and other parts (try to rewire), to avoid short-circuit failure;

4, will be completely dry electrical components separate inspection, after inspection intact can be installed before the use.

Third, the hydraulic part.

1, can not open the motor oil pump, because after opening the motor, the water into the hydraulic oil may enter the hydraulic line system of the machine, resulting in the corrosion of metal hydraulic components;

2, replace all hydraulic oil, before oil change to use washing oil and clean cotton cloth to wipe the tank clean.

Servo motors and control systems.

1, the system battery as soon as possible to remove, electrical components, circuit boards first cleaned with alcohol, dry with the wind and then dry for more than 24 hours;

2, the motor stator and rotor separate, stator winding drying treatment (can make professional repair motor treatment, can also be used 100W incandescent lamp deep into the motor shell drying processing for about 8 hours), insulation resistance must ensure that the motor bearing s.4M, motor bearing removed to use gasoline cleaning to check whether it can be used, otherwise replace the same specificationbearing;

After the above departments have been processed, the parts will be reassembled, electricity test machine.