What is the automatic tool setting system for precision parts processing?

 Around us, there are many precision parts processing. In the industry, there are still more used. It is precisely because of the many that it is necessary to use it for processing in various processing, so precise What is the automatic tool setting system for parts processing?

    Fine parts processing is to complete a variety of processes in automatic state numerical control equipment, mainly about some fixed mass production operations. However, regarding the mold industry and small-volume consumer units, do not go to the machining center at all times. Many manufacturers buy machining centers for use as CNC milling.

    Using the tool magazine is very simple for the cost of the CNC system, but the spindle, tool magazine, air compressor, and various tool holders will increase the cost, and programming and adjusting the tool magazine will also consume corresponding time. Therefore, do not use machining centers as far as possible with regard to less than one or two hundred workpieces of the same type, because of high cost and low efficiency.

    Fine parts processing can use the automatic tool setting system, the tool is loaded up, one button, the machine tool automatically measures the tool, and the machine is directly processed. The error is within 0.001~.0003mm, which is not much slower than the automatic change time. If it is a fine parts machining center, but the machine tool without automatic tool setting is compared with the machine tool without tool magazine but with automatic tool setting, the theoretical efficiency of the latter is much higher than the former.

   Regarding the domestic manufacturing industry, especially for mold consuming companies, it is usually a single piece of consumption, and labor resources are sufficient. Therefore, for the processing of small batch industrial parts, we must fully consider the application value of funds, and do not use processing centers at will equipment. What's more, there are still many problems with the tool magazines of domestic manufacturers.