Talking about how the operating steps of hardware processing should be

        Hardware is now a hot industry in this society, and hardware processing is to make its quality more perfect, so do you want to know what the steps of hardware processing look like? Let's find out together.

        1. Before entering the work position, all employees check whether their clothing meets the work requirements. Slippers, high heels and clothing that affect safety are not allowed, and those with long hair must wear a helmet. Maintain the correct posture at work and have sufficient energy to cope with the work. If you find that you are unwell, you should leave the job immediately and report to the leader. During operation, you must concentrate your thoughts, chat and cooperate with each other. The operator must not operate in a state of irritability and fatigue to avoid accidents and ensure safe operation.

        2. Before the machine works, check whether the moving part is filled with lubricating oil, then start and check whether the clutch and brake are normal, and run the machine idling for 1-3 minutes. It is strictly prohibited to operate when the machine is faulty.

        3. Turn off the power first when changing the mold, and then start to install and debug the mold after the press movement department stops running. After installation and adjustment, move the flywheel by hand to test punch twice, check whether the upper and lower molds are symmetrical and reasonable, whether the screws are firm, and whether the blank holder is in a reasonable position.

       4. You must wait for all other personnel to leave the working area of the machine and remove the sundries on the workbench before turning on the power to start the machine.

       5. After the machine is started, one person transports materials and operates the machine. Others are not allowed to press the electrical construction or foot switch board, let alone put their hands in the working area of the machine or touch the moving parts of the machine with their hands. When the machine is working, it is forbidden to reach into the working area of the slider, and it is strictly forbidden to pick and place the workpiece by hand. Standard tools must be used when picking and placing the workpiece in the die. If any abnormal sound or malfunction of the machine is found, the power switch should be turned off immediately for inspection.

       6. When leaving get off work, turn off the idle power and arrange the finished products, side materials and sundries on the job to ensure a clean and safe working environment.

      However, remember that the operating procedures must be consciously followed. Do not operate in violation of the rules or break down. You should cooperate with the maintenance personnel to check and repair. If the accident occurs, immediately cut off the power supply and keep the site reported to the factory until the process. All consequences caused by the violation of the operating procedures shall be borne by the parties. as a result of.