Blog

Pipe bends in the processing industry-a common problem with Pride's bends.

The positioning sleeve and the cage are not at the same horizontal line or the straightness is not enough, which causes the center of the copper tube

view more

Pride's pipe bender often has problems.

The straightening wheel of the equipment rotates on the outer wall of the copper tube at high speed. Because of the need to straighten and correct the

view more

Problems in the production of elbows

If it is feeding or the corner accuracy is poor. This is mainly to check whether the main material mold and pipe fittings are slippery. Mechanically,

view more

How is the servo elbow made?

Servo bending, you need to check whether the bending chain is loose. At the same time, the hydraulic oil of the pipe bender will also cause small erro

view more

How to improve the accuracy of pipe bending or pipe bending machine?

It is necessary to clarify whether the bending machine is the bending angle accuracy, the feeding length or the rotating pipe accuracy. If it is the a

view more

Pride Elbow Fittings Applicable to Aircraft Industry-- Best Fit Accuracy

The most commonly used is "best fit", which repeatedly fits the tangent points and midpoints of all straight sections of the pipe until the

view more

Pride elbow fittings applicable to the aircraft industry--precision requirements

The vector measuring machine with statistical average scanning technology uses these technologies to achieve a verifiable technology of +/-.005 inches

view more

Aircraft Conduit Elbow Inspection System--Accuracy of Measuring Machine

If the radial tolerance of the drawing is +/-.030 inches, the accuracy of the measuring machine should be +/-.0075 inches. Modern vector measuring mac

view more

Pride elbow fittings suitable for the aircraft industry-aircraft duct inspect...

The vector measuring machine for the aircraft catheter inspection system has been successfully used for the development of pipe fittings for many year

view more

Pride Elbow Fittings Applicable to Aircraft Industry--Problems in the Process...

Because titanium pipes tend to form bottlenecks locally, the bending speed should be slower than cold bending. The speed of bending the titanium pipe

view more

Pride elbow fittings suitable for aircraft industry--processing of titanium e...

The best effect is if the mandrel and die are heated. Precision interlocking tooling for bend titanium pipe. This requires the pipe to enter the pipe

view more

Pride elbow fittings suitable for aircraft industry--titanium elbow

Usually, three kinds of titanium are used: A40, A55, A70. Generally, A40 can bend twice the diameter at room temperature. Smaller radii or other mater

view more