Blog

Neoprene can also withstand certain acids and alkalis

Neoprene can also withstand certain acids and alkalis. Operating temperature is 80 °C. Butyl rubber is oil resistant and can be used at 80°C. Fluoroel

view more

Natural rubber has a certain acid and alkali resistance

Rubber flat gasket: easy to deform and press, but resistant to pressure and temperature difference, only suitable for low pressure and low temperature

view more

What are the types of rubber gaskets

Rubber Gaskets Rubber gaskets seal between two stationary surfaces in a metal flange or other connection area and are collectively referred to as rubb

view more

Rubber gaskets are thin-plate rubber products

Rubber gaskets are thin-plate rubber products that play a role in sealing between two static surfaces in metal flanges or other connecting grooves. Wi

view more

Unreasonable positioning of the parts

Unreasonable positioning of the parts during processing reduces the rigidity of the parts. Fourth, the existence of cutting force is also one of the r

view more

The unevenness of the lathe and the fixture causes uneven forces on both side...

The unevenness of the lathe and the fixture causes uneven forces on both sides of the parts when the parts are stopped and fixed, resulting in less fo

view more

When the operator stops positioning

When the operator stops positioning and clamping the part, the correspondence to the drawing plane cannot be stopped, simply causing elastic deformati

view more

There are several main reasons for the elastic deformation of parts during ma...

There are several main reasons for the elastic deformation of parts during machining. One is that if the internal structure of some parts contains fla

view more

For sheet mechanical parts

For sheet mechanical parts, due to their large long diameter, the straw hat simply turns around after stopping the heat treatment. On the one hand, th

view more

This ability to operate keeps the mechanical part stable during machining

This ability to operate keeps the mechanical part stable during machining. However, after the three-jaw or four-jaw chuck is released, the processed p

view more

in order to ensure that the parts do not loosen when subjected to force

At the same time, in order to ensure that the parts do not loosen when subjected to force and reduce the influence of the internal radial force, the c

view more

In the process of lathe machining

In the process of lathe machining, centripetal force is usually applied. The part is clamped with the three-jaw or four-jaw chuck of the lathe, and th

view more