How to solve the problem of cutting off the CNC milling machine?

Many times, CNC milling machine processing operators have a headache for the cutting angle during processing. How can we solve this problem?

The amount of knife eaten is relatively large, and it is easy to break the knife and flick the knife. At this time, you can first open the lower knife position or lift the knife away, or cut the knife outside the material in the day. In short, fully consider this issue. Grab the knife, flick the knife, drop the knife, when the processing volume is relatively large, the tool holder is too long, and this often happens when it is too small. The processing volume is relatively large, especially when the concentration of cutting is high, it is easy to happen, such as the depth of the smooth side H=50mm, the diameter of 3/4 cutting, we can divide the secondary processing of 25mm, and it is not easy to happen. The tool clamp is too long. The length of the tool is very important for processing. It should be as short as possible. It is easy for beginners to ignore this problem. The clamping length of the tool must be marked on the program paper. It is easy to grab a knife when turning a corner. The solution is to clear the corner layer by layer with a smaller knife, and then change the side of a larger knife.