How Does the Polisher Work Correctly?

First, the prelude to the assignment:

1. first of all to clean the work site, clean the work around the health, finishing idle items, will be unrelated to the work of the items clean, to be discharged into the appropriate position.

2. the polishing machine detection, power start polishing machine operation there is no abnormal situation, debugging fixed bolts solid loose.

3. polishing machine operating tools have complete conditions.

Second, normal operation:

1. in the process of operation of the polishing machine, must be in accordance with the requirements of the polishing machine to operate.

2. operators in the normal operation of the polishing machine should not wear gloves, which is the industry's clear provisions.

3. the operator must at any time self-test the effect of processing items, to see that the processing workpiece shaves there is no abnormal situation, such as deformation, cape, marks and other adverse effects, it is more necessary to maintain communication with the relevant staff at any time, in order to prevent serious errors.

4. the work of the polishing machine is normal and abnormal, as an operator can be by feeling or can hear the sound of the machine is not normal, of course, to immediately stop the work, troubleshooting the functional failure in order to operate normally.

5. professional professional operation, to the people to polishing machine are beneficial.

Third, After-care work:

1. after stopping the work, but also to keep the polishing machine around the clean, timely clean up the production of garbage.

2. operating tools placed in the set position, organize the discharge of processed products, put it in the appropriate position.

3. turn off the power, pull the device plug wire.

Steps for the use of the polishing machine

1. turn on, turn off the "emergency stop" button;

2. adjust the sink card position will be properly stuck in the sink, record the card data, the position of the caliper to take a picture (Note: the water hole is aligned to the center of the turntable);

3. the program name number, "reset" to the original position;

4. adjust the depth of the grinding wheel, pay attention to adjust the sensor lower limit position and screw position;

5. the existing data "data zero", press "debug stop", "debug start" light, debugging start, steps as follows:

(1) "Before the grinding wheel", move the grinding wheel forward to the appropriate position;

(2) "Workpiece is" will be rotated to a certain angle;

(3) "After the grinding wheel", the grinding wheel is moved back to the appropriate position, so that the grinding wheel and the sink arc close contact.

6. after the polishing machine completed debugging, the data "monitoring" to check whether there is abnormal data. If so, fix it;

7. after the correction is completed, press "debug start-up", debug start-up lamp out, debugging end;

8. check the polishing effect, make corrections, complete debugging.