What Should I Pay Attention to with A Polishing Machine?

The polishing machine is composed of some basic components such as base, disc sling, polishing fabric, polishing cover, etc. The motor polishing machine is fixed to the base, and the cone sleeve used in the fixed polishing disc is also connected by the shaft of the screw and the motor. The polished fabric is fastened to the polishing plate by a tight circle, and the motor, when the power is switched on, can be applied to turn the polish.

The key to polishing machine operation is to try to obtain a maximum polishing rate so that the damage layer caused by polishing can be removed as soon as possible. It also makes it necessary to make the polishing damage layer do not affect the final observed tissue. The use of coarser abrasives can ensure a larger polishing rate to remove the polished damage layer, polishing damage layer is also relatively deep. The latter uses finer materials, and the polishing damage layer is shallower.

For the above problem we can make the polishing in two stages, the purpose of coarse throwing is to remove the polished damage layer, this stage should have a large polishing rate, for the surface damage formed by coarse throwisised is a secondary consideration, but also should be as small as possible, the wire-pulling machine followed by fine throw it is intended to remove the resulting surface damage and then reduce the damage to minimize.

When polishing the polishing machine, the specimen grinding surface should be parallel to the polishing disc and evenly pressed on top of the polishing plate. Care should be taken to prevent the specimen from flying out or creating new grinding marks due to too much pressure, and should also make the specimen spin and move back and forth along the turntable radius. In order not to wear too fast to constantly add micropowder suspension, so that the polished fabric to maintain a certain humidity.

We need to do a check on the environment before using the polishing machine, the operator's hands and feet to stay away from the rotating polishing head, the operator can not step on the power cord or power cord to wrap into the polishing head, in the replacement or installation of light pads must cut off the power supply. If the operator has not received professional training or has not learned the safety operating procedures, polishing machine is not normal operation do not want to use high-speed polishing machine.