Bearing Heater Operating Order

The first step is to place the iron on the end face of the host.

The second step is to plug the plug into a power outlet with a control switch.

The third step, check whether the ground wire is good, power up with a measuring pen test.

The fourth step, according to the requirements of power, at this time the host automatically detects the probe, ambient temperature, and at the same time shows the ambient temperature.

The fifth step, check that the iron to the ground should be free of voltage.

Step 6, according to different specifications of bearings or other workpieces to select the iron sleeve, the iron on the top surface of the host, should be consistent with the flat.

Step 7, press the button, select temperature or time control, if you need to adjust the temperature or time, press the rise or fall of health, select the appropriate parameters.

Step 8, press the start button. The main unit starts heating the workpiece, and when the time is set, the host automatically stops heating and automatically demagnetizes the workpiece. At the temperature control, when the set temperature is reached, the workpiece is in a constant temperature state, need to install, press the stop button.

Step 9, when the bearing is heated to the desired temperature, the power supply will be switched off automatically or the stop switch will be pressed.

Step 10, stop the heating, the iron to the left or right, remove the bearing and put the iron back on top of the main unit.

Step 11, if the machine is reused, continuous heating of the bearings, only need to be processed bearings into the iron, press the start button can be.