Hardware Fastener Bolt With Internal

In the process of machining magnesium alloys, the powder produced has the risk of explosion, the generation of cutting heat increases in the same proportion as the cutting speed, the higher the relative temperature, the greater the possibility of fire, or some other factors All chips will reach the ignition point, so we should pay attention to reasonable operations in the machining of magnesium alloys. The magnesium waste chips produced by processing are packed in barrels and soaked in special cutting fluid for magnesium processing. Place it in a place that is ventilated but not exposed to rain or water, and do not cover the lid to allow the hydrogen that may be generated to volatilize naturally (the hydrogen may not be fully volatilized, which may cause an explosion).

Contact Us：

Email: zhang@pride-cnc.com

Tel: +86-755-23699351

Mob: +8618666663894