What Should I Pay Attention to When Processing Titanium Alloy?

A: Titanium turning is easy to obtain better surface roughness, hardening is not serious, but the cutting temperature is high, tool wear is fast. In view of these characteristics, the following measures are taken mainly in terms of tools and cutting parameters:

Tool geometry parameters: suitable tool front and rear angle, tip grinding circle. Lower cutting speed, moderate intake, deep depth of cutting, full cooling. The tip of the knife can not be higher than the center of the work piece when the exterior circle, otherwise it is easy to tie the knife, fine car and turning thin wall parts, the main angle of the tool should be large, generally 75 to 90 degrees. Titanium alloy should consider cutting or blade wear resistance.

Titanium alloy is a non-ferrous metal category, must be cut in the knife and blade wear resistance. It is best to use a blade with a smaller tip angle and a larger rear corner.