What happens if the cnc processing sequence is unreasonable? How to solve the dispersion of cnc processing procedures?

For CNC machining companies, it is relatively common to use cnc processing. This is because the use of cnc processing equipment for processing has high efficiency and good quality, but if the process design is improperly arranged, its advantages will not be well demonstrated. According to the editor's understanding, from the experience analysis of some CNC processing manufacturers, there are two common problems as follows.

What happens if the cnc processing sequence is unreasonable?

Some cnc processing operators take into account some problems in preparation, and often arrange the processing sequence extremely unreasonably. CNC machining is usually processed according to the requirements of general mechanical processing technology, such as first coarse and then fine (tool change), first inside and then outside, reasonable selection of cutting parameters, etc., so that quality and efficiency can be improved.

Use G00 (G26, G27, G29) fast positioning instructions with caution. The G00 instruction brings great convenience to programming and use. However, if the setting and use are improper, it will often result in undesirable consequences such as overshoot when returning to zero due to excessive speed setting, loss of accuracy, and strain on the guide rail surface of the equipment. If you don't pay attention to the zero return route, it is easy to cause safety accidents that collide with the workpiece and equipment. Therefore, when considering the use of the G00 command, you should consider it thoroughly and not arbitrarily.

In CNC machining, especially attention should be paid to strengthening the retrieval and trial operation of the program. After the program is entered into the control system, the operator should use the SCH key and the ↑, ↓, ←, → movement keys to perform uncertain and definite retrieval, and modify the program if necessary to ensure the accuracy of the program. At the same time, before the formal execution of the program processing, the program must be tested (turn on the power amplifier) to confirm whether the processing route is consistent with the design route.

How to solve the dispersion of cnc processing procedures?

The reason for this problem lies in the fear of complexity (referring to the preparation time), simple programming, simplified operation and processing, easy adjustment of tool setting with one tool, and accustomed to ordinary processing. As a result, product quality (position tolerance) is not easy to guarantee, and production efficiency cannot be brought into full play. Therefore, cnc processing technicians and operators should be fully familiar with numerical control processing knowledge, try more to master relevant knowledge, and use process-intensive methods for processing as much as possible. If you use it several times, it will naturally reflect its advantages. After the use of process concentration, the unit processing time increases. We arrange the two equipment face to face, and realize that one person can operate the two equipment. The efficiency is greatly improved, and the quality is also very well guaranteed.