What Are the Cave Drilling Needs to Be Considered When Using It?

One. Check the amount of coolant stored in motor spindle cooling before use, turn on the motor's spindle cooling, and ensure proper coolant circulation. Open the positive pressure seal to avoid processing waste fluid, coolant, etc. into the motor spindle bearings.

Two. Card materials must be solid, must follow the "loading, loading, flat" principle, is strictly prohibited in the material hanging place for carving.

Three. When installing the card tool, the dust and debris in the card head must be cleaned up, the card head is loaded into the pressure cap and is correct, and then together on the motor spindle and the tool inserted into the card head, and finally the pin press cap. It is strictly forbidden to use the push and pull method and to rotate when the upper and lower knife loosens the tight cap. When the knife should first clean the pressure cap and turn on the waste, loosen the pressure cap to take the tool down and then unscrew the pressure cap out of the card head.

Four. When loading a loaded tool, the length of the tool to reveal the card head must refer to the engraving depth file, depending on the fixture. In the conditions to expose the length of the card head as short as possible, when the total length of the tool is less than 22mm, it is strictly prohibited to continue to use.

Five. When loading a loaded cutter, the length of the handle extended into the card head must be greater than 18mm.

Six. Cutting fluid must be flushed onto the tool during machining.

Seven. During the carving process, close observation is strictly prohibited to prevent chips from flying into the eyes. Pause the engraving while observing, close the motor spindle and determine that the motor spindle is no longer rotating. During the carving process, it is strictly forbidden to touch the cutting surface by hand, and the use of cotton wire to wipe the working surface is prohibited.

Eight. It is strictly forbidden to place any thing on the machine tool countertop or beam, to hold hands on the machine bed body such as beams and protective covers, and to rest on the machine bed body.

Nine. It is strictly forbidden to knock, hit the motor spindle, and it is strictly forbidden to knock when removing the knife.

Ten. Do not use the machine in hot or too cold conditions. Deep hole drill.

Eleven. Deep hole drilling rig is a light processing equipment. The sum of tooling fixtures, workpiece weights and processed waste sands should not exceed the rated weight of the machine.

Twelve. Before carving carefully check the size of the tool used, whether the performance meets the machining programming requirements.

Thirteen. Carefully check that the toolpath is correct before machining.

Fourteen. Be sure to re-verify that the axle stab points (working origin) are correct before starting processing.

Fifteen. The motor spindle must be rested by 2h every day.

Sixteen. It is strictly prohibited to charge wires, boards and electrical parts, and when processing flammable materials such as organic materials, effective fire prevention measures should be present at the work site.

Seventeen. 10 minutes before work every day, refuel the machine to lubricate and scrub the machine cleaning machine. Confirm that the machine is stopped, stop the machine at the specified position, turn off the power, and confirm that all switches are disconnected before leaving.