The Repair and Maintenance of Flat Milling Machines Is Complete

If the flat milling machine does not carry out proper maintenance, in the process of use is easy to appear unnecessary operational errors, because its components simple and intelligent too high, CNC tools emerged, many operators do not know how to properly repair and maintain CNC machine tools. Let's talk about the maintenance of flat milling machines.

The flat milling machine covers the operating range.

1. Cleaning of beds and components, cleaning iron chips and surrounding environmental hygiene;

2. Check the oil plane, not below the oil label, fill each part of the lubricant;

3. Cleaners, clips, weights. A flat milling machine guarantees a job range.

1. Cleaning and adjustment work station, silk rod handle and column paneling;

2. Check and adjust the clutch;

3. Cleaning three guide rails and linoleum, electric motor, machine inside and outside and accessories cleaning;

4. Check the oil path and fill each part of the lubricant;

5. Tighten the screws.

The flat milling machine covers the operating range.

1. Cleaning work of bed bodies and components, cleaning iron chips and surrounding environmental hygiene, cleaners, clips, weights;

2. Check the oil level, not below the oil label, fill each part of the lubricant.

The scope of the weekend maintenance work of the flat milling machine.

First, clean.

1. Remove and clean all linoleum mats;

2. Wipe the sliding surfaces and rail surfaces, wipe the work table and landscape, lift the wire rod, wipe the passing knife transmission mechanism and knife frame;

3. Wipe the dead ends.

Second, lubrication.

1. Each oil hole is clean and smooth and filled with lubricant;

2. Each rail surface and sliding surface and each wire rod filled with lubricant;

3. Check the drive mechanism tank body, oil surface, and refuel to the height position.

Third, twist tight.

1. Check and tighten the pressure plate and the panel screws;

2. Check and twist the slider fixing screws, walking knife transmission mechanism, handwheel, work table support screws, fork top wire;

3. Check that the rest of the screws are loose.

Fourth, adjustment.

1. Check and adjust the belt, pressure plate and strip loose fit;

2. Check and adjust the slider and screw joint order.

V. Anti-corrosion.

1. Remove the rust of each part, protect the paint surface, do not collide;

2. Deactivation, spare equipment rail surface, sliding wire rod handwheel and other exposed to rusty areas oil anti-corrosion.