The daily maintenance method of CNC machining center manufacturers, necessary to do machining

The daily maintenance method of CNC machining center manufacturers, necessary to do machining

Do a good job in the protection of CNC machining center manufacturers to ensure that the machining accuracy of the machine adheres to the best situation, extend the service life of the machine, and provide you with several experiences in metal processing to help you improve your ability to protect.

Matters needing attention: After the machine is launched, it prevents the protection of the CNC machining center. During the protection process, the circuit breaker should be opened.

Processing accuracy insists:

1. After starting, it is necessary to preheat for about 10 minutes before processing. Machines that are not used for a long time should extend the warm-up time.

2. Check whether the oil road is cleared

3. Put the worktable and saddle in the center of the machine before turning off (move the three-axis travel to the center of the travel of each axis).

4. The CNC machining center insists on monotonous cleaning.

1. Daily protection and maintenance of processing center

1. Check the level of lubricating oil in the machining center to ensure the lubrication of the CNC machining center. It is recommended to use T68# rail lubricant.

2. Check whether the coolant in the coolant tank of the machining center is satisfactory and cannot be added in time.

3. Check the oil level of the pneumatic triplet of the machining center, which is about 2/3 of the height of the entire tubing. Every day, the water in the oil filter tank of the pneumatic triple unit is discharged by the drain switch.

4. Check the air pressure of the machining center, loosen the adjustment knob, adjust the pressure according to the principle of right-hand pressure increase and left-hand pressure reduction, generally set to 5 ~ 7KG/CM2. The pressure switch is generally set to 5 KG/CM2. When the pressure is lower than 5KG/CM2, the system will alarm, and the system will display a "LOW AIR PRESSURE" alarm. After the pressure increases, the alarm message will disappear.

5. Check whether the air blowing in the cone hole in the spindle of the machining center is normal, wipe the cone hole in the spindle with a clean cotton cloth, and spray light oil.

6. Clean the arms and tools of the tool magazine of the machining center, especially the claws.

7. The limit switches and bumps exposed by the cleaning and processing center.

8. Eradicate the cutting and greasy dirt on the working table of the machining center, the CNC machining center, and the three-axis elastic shield.

9. Check all the signal lights of the machining center and whether the warning lights are normal.

10. Check if there is any leakage in the hydraulic unit tube of the machining center.

11. The CNC machining center performs cleaning and cleaning operations after the daily operations.

12. Adhere to a regular environment around the machine.