The Common Faults of CNC Gearing Machines and Their Solutions Are Complete

The tooth roller is one of the most widely used machine tools in gear processing machine, which can cut straight teeth, oblique teeth cylindrical gear, and can also process worm wheels, sprockets and so on. Today we'll talk about the common failures of CNC gearers and their solutions.

Let's first look at the troubleshooting of the CNC roller machine, precautions:

First, you need to understand the symptoms of the fault, see what faults have occurred on the device, and check the fault. Before checking the fault of the CNC gear ingress, a power cut is required, after the power loss, and then the check is made.

Secondly, to find out the specific cause of the nccontrol roller failure. After a professional maintenance personnel inspection, to find out the equipment can not run normally the cause, in the end, which caused the failure.

The fault of the CNC roller is then treated. After checking out the specific cause, the fault needs to be addressed. When dealing with, pay attention to the handling methods, such as the discovery of wiring errors, the line needs to be adjusted in a timely manner.

Summarize. A failure of the CNC tooth roller is an accumulation of experience for the user and a lesson to avoid the same failure of the equipment in the next operation.

The numerical control of the power failure, the more important one, in fact, it does not have a power supply voltage or low supply voltage, for the CNC roller system, in general, in fact, it is also directly used to use the .5V, s12V, s15V, s24V, in a few cases, that is, the use of the power supply voltage is not normal, in fact, it will cause abnormal work on the system.

Immediately after, for the circuit failure of the CNC roller, in fact, that is, when we use the voltage meter to detect the power supply, it is relatively normal on the performance of the voltage, however, when it is detected with an oscilloscope, it is actually to find its voltage wavewave ripple large. In fact, it is because the power filter capacitor appears open circuit, followed by, that is, because of its rectifier diode bad or because of false welding caused, sometimes, is a component breakdown damage caused by the power supply load too heavy situation.

The CNC gear inge machine system is normal when it is just turned on, and the supply voltage drops until it has been working for a period of time. In fact, it is also because of the numerical control of the power supply of the regulator circuit or high-power three-pole tube appeared bad. Just after the temperature increase, to a certain extent, that is, will cause the power supply voltage drop, or may be because of the numerical control of the tooth machine power supply on a certain component appeared false welding, after the temperature rise after the phenomenon of poor contact, for this phenomenon we should find out and exclude.

When troubleshooting the fault of the CNC gear machine, it is possible to operate according to the above method and easily correct the fault.