Motor Parts With Anodized Aluminium

Aluminum is soft and the mold is relatively simple. CNC processing manufacturers tell you that when designing the gap between the molds, it is advisable to thicken the gap between the two fabrics by 10%, the straight depth of the knife edge is 2MM, and the taper is 0.81°. For gold stamping parts that need post-anodizing processing, if there is a flattening and flattening process, the product cannot be completely pressed at 180 degrees, and the phenomenon of acid spitting will occur when it is completely pressed. A gap of 0.20.3MM needs to be left so that the acid can be smoothly Outflow, so this process needs to be a limit block to calibrate the height of the mold. All aluminum parts need to be cut with slow-moving wire to avoid burrs and unsmooth blanking. Aluminum parts are prone to high temperature, so the hardness of the punch should be above 60°, at least SKD11 material should be used, and poor quality punches such as D2 should not be used. .

Contact Us：

Email: zhang@pride-cnc.com

Tel: +86-755-23699351

Mob: +8618666663894