Motor Bearing Installation Steps

1. Bearings washed with kerosene, pressed into the bearing seat, filled shell iii lithium-based grease to two-thirds full at the rollers of the bearing outer ring, applied evenly with clean hands, fitted with bearing caps, and tightened bearing caps with fastening bolts coated with bolts against loose glue;

2. Bearings are cylindrical roller bearings that can be separated from the inner coat, and the bearings should be placed on the shaft and in place;

3. The housing is mounted on the housing, if there is a grease fill hole, must be aligned to the position. tightening the housing with the fastening bolts coated with bolts against loose glue;

4. The inner and outer eccentric block is mounted on the shaft and in place, the axis key holder should load the shaft key into the key slot and then install the outer eccentric block, the shaft with the bezel mounted on the shaft;

5. Tighten the eccentric block fastening the bolts and turn the adjustable eccentric block so that it reaches the angle position before the removal and tightens its fastening bolts. After the above assembly is completed, the shaft should have a certain axial string;

6. The protective cover at both ends of the vibration motor is tightened with screws.