How to replace your catch net

• Be careful when removing all accessories as you will need to

These are used for reassembly

• Cut the ties to remove the old mesh

• Remove the bolts from the plastic shroud on top of the rod, then

Remove the protective cover

• Slip off the old net

• Pass the open end of the net through both the cable and the pole. Make sure there is slack on the cable side so that

The net can be opened. There should be no slack on the rod side

• Put all accessories back loosely in their original positions - do not

tighten

• Test the network to make sure it works and make any

Adjustment needed

• If the mesh is functioning properly, now tighten the installed bolts

Pass through the plastic shield and zip tight

Please contact us at zhang@pride-cnc.com