How to Regulate Operation and Use Deep Hole Drills?

When we are using CNC deep hole drilling, we must pay attention to whether our operation is standardized, whether the operating procedure is reasonable. So what should we pay attention to?

First of all, we must wear our work clothes before work, the cuffs of work clothing must be tied up, can not be scarf, can not wear gloves, if you are a girl, long hair, then you must put their own pigtails in their own hat.

Second, be sure to check the equipment in advance, check the equipment protection, insurance, signal settings and so on. In the part of the mechanical transmission, the electrical part must have a reliable protective setting is possible. Also check whether the tools and tools are intact, otherwise you can not prepare to start.

Third, pay attention to the deep hole drill platform must be tight, there are workpieces must be clamped. When we drill small pieces, be sure to use special tools for clamping, in order to prevent the processing parts with rotation, but also note that can not be held by hand or press drilling.

Fourth, in the automatic knife, be sure to choose the speed of the feed, to adjust the travel limit that part. Note that when manually entering the knife, be sure to carry out according to the principle of gradual pressure and decompression, to prevent excessive force and cause unnecessary accidents.

Fifth, in certain circumstances, we must stop, for example, when we adjust the speed of the deep hole drill, travel, clamps and workpieces, or when wiping the machine, in these circumstances, must stop.