Briefly describe what problems should be paid attention to in CNC parts processing?

    Nowadays, with the continuous improvement of science and technology, our industry needs a variety of processing. In the process of processing, we will inevitably have various problems or problems that we need to comply with. Then CNC parts processing What issues should be paid attention to?

   1. Must abide by the machining center safety operating procedures.

   2. Before work, you should wear protective equipment, tie up your cuffs, and are not allowed to wear scarves, gloves, ties, or aprons. Female workers should wear their hair braids in their hats.

   3. Check whether the tool compensation, machine zero point, workpiece zero point, etc. are correct before starting up.

 Dongguan CNC parts processing

   4. The relative position of each button should meet the operating requirements. Carefully compile and input CNC programs.

   5. Check the operating conditions of the system such as hungry protection, insurance, signal, position, mechanical transmission part, electrical, hydraulic digital display, etc. on the equipment, and cutting can be carried out under all normal conditions.

   6. Before the CNC machining, the machine tool should be checked for the operating conditions of the lubrication, mechanical, electrical, hydraulic, digital display and other systems. Cutting can be performed under all normal conditions.

   7. After the machine tool enters the processing operation according to the program, the operator is not allowed to touch the mover's workpiece, cutter and transmission part, and it is forbidden to pass or take tools and other items through the machine tool transmission part.

   8 When adjusting the machine tool, clamping workpieces and tools, and wiping the machine tool, it must be stopped.

   9. Tools or other items are not allowed to be placed on electrical appliances, operation cabinets and protective covers.

 Dongguan CNC parts processing

   10. It is not allowed to directly remove iron filings by hand, and special tools should be used for cleaning.

   11. If abnormal conditions and alarm signals are found, stop immediately and ask relevant personnel to check. CNC machining center.

   12. It is not allowed to leave the work post when the machine tool is turning. When leaving for some reason, place the workbench in the middle position, the tool bar returns, and the machine must be stopped and the power supply of the host must be cut off.